W.3108002
Explanation: GPT Corruption happened
Severity: Warning
User response: Complete the following steps:
1. Check hard disk data integrity,Check PCIE storage cards option rom firmware version and function if hard disks
connected to the PCIE storage cards.
W.3808000 [W.3808000] An IMM communication failure has occurred.
Explanation: IMM Communication Failure
Severity: Warning
User response: Complete the following steps:
1. Reset IMM.
2. Remove power from the node. This will reboot the entire node.
3. Check IBM support site for an applicable RETAIN tip or firmware update that applies to this error.
4. Reflash UEFI Firmware.
5. (Trained service technician only) Replace IO board.
W.3808002 [W.3808002] An error occurred while saving UEFI settings to the IMM.
Explanation: Error Updating System Configuration to IMM
Severity: Warning
User response: Complete the following steps:
1. Use F1 Setup, Verify Settings and Save Settings to recover settings.
2. Reset IMM.
3. Remove power from the node. This will reboot the entire node.
4. Check IBM support site for an applicable RETAIN tip or firmware update that applies to this error.
5. Reflash IMM Firmware.
6. Remove and re-install CMOS battery for 30 seconds to clear CMOS contents.
7. Trained Service technician only) Replace IO board.
W.3808003 .[W.3808003] Unable to retrieve the system configuration from the IMM.
Explanation: Error Retrieving System Configuration from IMM
Severity: Warning
User response: Complete the following steps:
1. Use F1 Setup, Verify Settings and Save Settings to recover settings.
2. Reset the IMM.
3. Remove power from the node. This will reboot the entire node.
4. Check IBM support site for an applicable RETAIN tip or firmware update that applies to this error.
5. Reflash IMM Firmware.
6. Remove and re-install CMOS battery for 30 seconds to clear CMOS contents.
7. Trained Service technician only) Replace IO board.
W.3108002 • W.3808003
Appendix C. UEFI/POST error codes 1021
To Next Page
Loading...
Need help?
General