EasyManuals Logo

IBM X3950 X5 User Manual

IBM X3950 X5
1064 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #89 background imageLoading...
Page #89 background image
If you are unable to restart the server or if you need comprehensive diagnostics,
use DSA Preboot.
Running DSA Preboot
This topic provides steps for how to run DSA Preboot.
To run DSA Preboot, complete the following steps:
1. If the server is running, turn off the server and all attached devices.
2. Turn on all attached devices; then, turn on the server.
3. When the prompt <F2> Diagnostics is displayed, press F2.
Note: DSA Preboot might appear to be unresponsive for an unusual length of
time when you start the program. This is normal operation while the program
loads.
4. (Optional) Select Quit to DSA to exit from the stand-alone memory diagnostic
program.
Note: After you exit from the stand-alone memory diagnostic environment,
you must restart the server to access the stand-alone memory diagnostic
environment again.
5. Select gui to display the graphical user interface, or select cmd to display the
DSA interactive menu.
6. Follow the instructions on the screen to select the diagnostic test to run. If the
diagnostic tests do not detect any hardware errors but the problem remains
during normal server operation, a software error might be the cause. If you
suspect a software problem, see the information that comes with your software.
Recovering the server firmware
This topic provides general information about recovering the server firmware.
The flash memory in the server consists of a primary bank and a backup bank. You
must maintain a bootable IBM UEFI firmware image in the backup bank. If the
UEFI firmware in the primary bank has become corrupted, such as from a power
failure during an update, you can recover the UEFI firmware in either of two
ways:
v In-band method: Through the automatic boot recovery function (automatic) or
using the boot recovery jumper and an IBM Flash UEFI Update (manual)
v Out-of-band method: Using the IMM web interface and an IBM Flash UEFI
Update
You can obtain an IBM Flash UEFI Update package from http://www.ibm.com/
supportportal/or from your IBM service representative.
Chapter 3. Diagnostics 73

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM X3950 X5 and is the answer not in the manual?

IBM X3950 X5 Specifications

General IconGeneral
BrandIBM
ModelX3950 X5
CategoryServer
LanguageEnglish

Related product manuals