A single problem might cause multiple symptoms. Follow the troubleshooting
procedure for the most obvious symptom. If that procedure does not diagnose
the problem, use the procedure for another symptom, if possible.
If the problem remains, contact IBM or an approved warranty service provider
for assistance with additional problem determination and possible hardware
replacement. To open an online service request, go to . Be prepared to provide
information about any error codes and collected data.
Undocumented problems
If you have completed the diagnostic procedure and the problem remains, the
problem might not have been previously identified by IBM. After you have
verified that all code is at the latest level, all hardware and software configurations
are valid, and no light path diagnostics LEDs or log entries indicate a hardware
component failure, contact IBM or an approved warranty service provider for
assistance.
To open an online service request, go to . Be prepared to provide information
about any error codes and collected data and the problem determination
procedures that you have used.
Chapter 1. Start here 3
To Next Page
Loading...
Need help?
General