13
2
MENU MODE
New2001 New2001
DUP/TONE items
Settings to access repeaters.
Tone*
Sets a channel tone type.
Frequency offset*
Sets the frequency offset for duplex (repeater) operation.
Repeater tone*
Sets a tone frequency used to access repeaters.
TSQL frequency*
Sets a tone frequency for the Tone squelch function used in the
FM mode.
Tone burst
Turns the Tone Burst function ON or OFF.
This function is used to suppress the squelch tail noise heard from
the called transceiver’s speaker.
DTCS code*
Sets a DTCS (both encoder/decoder) code for DTCS squelch
function used in the FM mode.
DTCS polarity*
Sets the DTCS polarity for the DTCS squelch function.
Scan items
Set scan options.
Priority scan*
Starts the Priority scan.
Pause timer*
Selects the scan pause time. When receiving signals, the scan
pauses according to the scan pause timer.
Resume timer*
Selects the scan resume time from a pause after the received sig-
nal disappears.
Temporary skip timer
Selects the Temporary Skip Time. When the time is set, specified
frequencies are skipped for this period during a scan.
Weather alert*
Sets to sound a beep when a weather alert signal is detected on a
preset weather channel. (Only for the USA version transceiver)
Program skip scan
Turns the Program Skip Scan function ON or OFF for a VFO mode
scan.
Bank link
Selects banks to be scanned during a Bank link scan.
Program scan edge
Sets the frequency ranges for the Program scan.
Program scan edge
Displays 25 Program scans.
Name
Enters a name into each Program scan.
Frequency low
Sets the lower edge frequency for each Program scan.
Setting items ■
EXMENU mode (Continued) D
*You can set in the MENU mode.
To Next Page
Loading...
Need help?
General
