EasyManuals Logo

Icom i2730A User Manual

Icom i2730A
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
New2001New2001
ii
R DANGER HIGH VOLTAGE! NEVER touch an antenna
connector during transmission. This may result in an electrical
shock or burn.
R WARNING RF EXPOSURE! This transceiver emits Ra-
dio Frequency (RF) energy. Extreme caution should be observed
when operating this transceiver. If you have any questions re-
garding RF exposure and safety standards please refer to the
Federal Communications Commission Office of Engineering and
Technology’s report on Evaluating Compliance with FCC Guide-
lines for Human Radio Frequency Electromagnetic Fields (OET
Bulletin 65).
R WARNING! NEVER operate the transceiver while driving
a vehicle. Safe driving requires your full attention—anything less
may result in an accident.
R WARNING! NEVER operate the transceiver with an ear-
phone or other audio accessories at high volume levels. Continu-
ous high volume operation may cause a ringing in your ears. If you
experience ringing, reduce the volume level or discontinue use.
R WARNING! NEVER connect the transceiver to an AC out-
let. This may pose a fire hazard or result in an electric shock.
R WARNING! NEVER connect the transceiver to a power
source of more than 16 V DC such as a 24 V DC. This could
cause a fire or damage the transceiver.
R WARNING! NEVER reverse the DC power cable polar-
ity when connecting to a power source. This could damage the
transceiver.
R WARNING! NEVER cut the DC power cable between the
DC plug and fuse holder. If an incorrect connection is made after
cutting, the transceiver may be damaged.
R WARNING! NEVER let metal, wire or other objects touch
any internal part or connectors on the rear panel of the trans-
ceiver. This may result in an electric shock or this could cause a
fire or damage the transceiver.
R WARNING! NEVER operate or touch the transceiver with
wet hands. This may result in an electric shock or may damage
the transceiver.
R WARNING! Immediately turn OFF the transceiver power
and remove the power cable if it emits an abnormal odor, sound
or smoke. Contact your Icom dealer or distributor for advice.
CAUTION: NEVER expose the transceiver to rain, snow or
any liquids.
CAUTION: NEVER change the internal settings of the trans-
ceiver. This may reduce transceiver performance and/or damage
to the transceiver.
CAUTION: NEVER place the transceiver where normal op-
eration of the vehicle may be hindered or where it could cause
bodily injury.
DO NOT operate the transceiver near unshielded electrical
blasting caps or in an explosive atmosphere.
DO NOT push the PTT when not actually desiring to transmit.
PRECAUTIONS

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom i2730A and is the answer not in the manual?

Icom i2730A Specifications

General IconGeneral
BrandIcom
Modeli2730A
CategoryTransceiver
LanguageEnglish

Related product manuals