36
5
SCAN OPERATION
New2001
5
SCAN OPERATION
■ About the scan function
D VFO scan (p. 41)
•ALL (Full scan)
Repeatedly scans the entire band.
118 MHz 550 MHz
Scan
P SKIP
P SKIP
Jump
•BAND (Selected band scan)
Scans all frequencies over the entire selected band.
Band edge Band edge
Scan
P SKIP
P SKIP
Jump
•PROG 0~24 (Program scan)
Scans the program scan edge range.
Band
edge
Lower
freq.
Higher
freq.
Band
edge
Scan edges
ScanJump
Jump
•P-LINK0~9 (Program link scan)
Sequentially scans the program scan edge ranges which
are set to link in the “P-LINK” (Program Link) item of the
EXMENU mode. (p. 14)
For your reference: The frequencies that are set as
“PSKIP” are not scanned. (p. 13)
NOTE: At least one program scan edge range must be
programmed to start a program scan. (p. 38)
D Memory scan (p. 43)
•ALL (Full memory scan)
Scans all Memory channels.
•BAND (Selected band memory scan)
Scans all Memory channels in the same frequency band as
the selected channel.
•MODE (Mode memory scan)
Scans Memory channels that are programmed with the
same receiving mode as the currently selected mode.
D Memory bank scan (p. 43)
•ALL (Full bank scan)
Scans all banks.
•B-LINK (Bank link scan)
Sequentially scans the banks that are set to link in the
“B-LINK” (Bank Link) item of the EXMENU mode.
•BANK-A~J (Bank scan)
Scans the Memory channels in the selected bank.
For your reference: The frequencies that are set as
“PSKIP” or “SKIP” are not scanned. (p. 44)
NOTE: Two or more memory channels must be pro-
grammed to start a Memory scan.
To Next Page
Loading...
Need help?
General
