Icom i2730A - Setting and Clearing Skip Frequencies

New2001
42
5
SCAN OPERATION
New2001
5
SCAN OPERATION
D Setting the skip frequencies
The frequencies set as “PSKIP” channels are not scanned.
Start the VFO scan. (p. 41) q
 •Whenasignalisreceived,thescanpauses.
To skip the frequency, hold down [MW] w C for 1 second (un-
til 3 beeps sound) while the scan is paused.
 •Whenasignal isreceivedduringthescan, thetransceiver at-
tempts to enter the frequency as a skip channel into empty
memory channel 999.
Skip frequency is entered
into channel 999.
Blinks
 •Ifchannel999alreadyhascontent,thetransceiverautomatically
searches for another blank channel to enter.
If no blank memory channel is found, a beep sounds, and no skip
channel is set.
After the skip channel is set, the scan resumes. e
■ Setting and clearing the skip frequencies
For your reference:
The skip setting is also cancelled when the memory chan-
nel set as a skip channel is deleted. (p. 35)
D Clearing the skip frequencies
Push [MR CALL] q S.
 •SelectstheMemorymode.
Rotate [DIAL] w S to select the memory channel you want to
clear as a skip channel. (Example: 999)
Push [MW] e C to display the Memory edit screen.
Rotate [DIAL] r
S to select “EDIT.”
Push [ t ï]D.
Rotate [DIAL] y
S to select “SKIP.”
Push [ u ï]D.
Rotate [DIAL] i
S to select “OFF.”
Push [ o ï]D.
!0 Rotate [DIAL]
S to select “WRITE.”
 •Displays“OVERW?.”
!1 Rotate [DIAL]S to select “YES.”
!2 Push [ï]D.
 •Beepssound.
 •Clearstheskipsetting.
The C, S, or D in the instructions indicate the area of the
controller.
C: Center, S: Side, D: Display