12
SCAN OPERATION
12-10
Previous view
Memory scan D
A Memory scan searches for signals through Memory
channels 1 to 99.
Blank (unprogrammed) Memory channels are skipped.
NOTE: For a Memory scan to start, two or more
Memory channels must be programmed. (p. ??-??)
Touch the Memory channel number indication once q
or twice to select the Memory mode. (p. ??-??)
Push w
MENU
(C) one or more times to select the “M-
1” (Menu 1) screen.
e
Touch
[SCAN](D) to display the “SCAN” screen.
Set [RF/SQL] open or closed. r
• The scan performance differs, depending on the squelch
setting when the scan was started. See page 146 for de-
tails.
• If the [RF/SQL] control function is set to “AUTO,” the
squelch is always open in the SSB, CW and RTTY
modes. (pp. ??-??, ??-??)
Touch [MEMO]( t D) to start the Memory scan.
• The MHz and kHz decimal points, and “MEMO SCAN”
blink while scanning.
• If “Up/Down” is selected as the “MAIN DIAL (SCAN)” op-
tion in the Scan Set mode, rotating the Dial changes the
scanning direction. (p. ??)
Touch [MEMO]( y D) to cancel the scan.
While Memory scanning
Touch
[SCAN]
Touch [MEMO]
Memory scan (Memory mode)
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch panel)
L
eft
R
ight
C
enter
D
isplay
To Next Page
Loading...
