Icom IC-7100

6
FUNCTIONS FOR TRANSMIT
6-3
Previous view
Break-in function
(Mode: CW )
The Break-in function is used in the CW mode to auto-
matically toggle the transceiver between transmit and
receive when keying. The IC-7100 is capable of Full
Break-in or Semi Break-in.
Semi Break-in operation D
During Semi Break-in operation, the transceiver imme-
diately transmits when you key down, then returns to
receive after a preset delay time has passed after you
stop keying.
Select the desired frequency band. (p. 3-5) q
On the Mode selection screen, select the CW or w
CW-R mode. (p.3-??)
Push e
MENU
(C) one or more times to select the
“M-3” screen (M-3 menu).
Touch [BK-IN]( r D) one or more times
to turn ON the
Semi Break-in function.
• “BKIN” appears.
When the “M-3” screen (M-3 menu) is selected, t
touch [BK-IN](D) for 1 second to display the “BK-IN”
screen.
Touch [ y Y] or [Z](D) to select the desired item.
Rotate the Dial u to select the desired option.
• If desired, touch [DEF](D) for 1 second to reset to the
default setting.
Push i
MENU
(C) to exit the “BK-IN” screen.
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch panel)
L
eft
R
ight
C
enter
D
isplay
Touch [BK-IN]
Touch for 1 second
to reset to default
Semi Break-in icon
Shows break-in delay time
Touch [BK-IN]
for 1 second