Icom IC-7100

11
MEMORY OPERATION
11-9
Previous view
The Memory channel contents (frequency, operating
mode, and so on.) can be copied to the VFO.
Copying in the Memory mode D
Touch the Memory channel number indication once q
or twice to select the Memory mode. (p. ??-??)
Rotate [BANK]( w L) or [M-CH](L) to select the Mem-
ory channel to be copied.
• “BLANK” appears if the selected Memory channel is a
blank channel. In this case nothing can be copied.
Touch [V/M]( e D) for 1 second to copy the Memory
channel contents into the VFO.
Touch the Memory channel number indication to se- r
lect the VFO mode. (p. ??-??)
Copying in the VFO mode D
In the VFO mode, select the Memory channel num- ➥
ber to be copied. And then, touch [V/M] for 1 second
to copy the Memory channel contents into the se-
lected VFO.
• “BLANK” appears if the selected Memory channel is a
blank channel. In this case nothing can be copied.
Touch [V/M]
for 1 second.
Touch [V/M].
The Memory
channel contents
are transferred into
the selected VFO.
( The display does
not change.)
Copying Memory contents
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch panel)
L
eft
R
ight
C
enter
D
isplay