17
SET MODE
17-2
Previous view
The Set mode is used to program infrequently changed
values or function settings.
NOTE: The Set mode is constructed in a tree struc-
ture. You may go to the next tree level, or go back a
level, depending on the selected item.
w
e
r
u
t
y
The Set mode settings D
Push q
SET
(C) to enter the Set mode.
If the specifi ed item is not displayed, touch [ w ∫] or [√]
(D) one or more times to select the page.
• If [∫](D) or [√](D) is continuously held down, the pages
are quickly scrolled.
• Rotating the Dial also selects the pages.
Touch the desired item to go to the next level. e
Repeat steps rw and e to show the desired item’s
setting screen.
• To go back the previous tree level, touch [](D), or
MENU
(C).
Touch a desired option shown on the display, or [+]/ t
[–](D) to adjust a level.
• When you touch an option, it is automatically saved and
the screen returns to the previous display.
• Rotating the Dial also adjusts the level.
• Push
QUICK
(C), and then touch “Default” to reset to the
default setting, if desired.
• To set other item, touch [](D), or
MENU
(C) to go back
a tree level.
Push y
SET
(C) to exit the Set mode.
Set mode description
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch panel)
L
eft
R
ight
C
enter
D
isplay
To Next Page
Loading...
