Icom IC-7100

13
USING AN SD CARD
13-13
Previous view
Inserting the SD card4.
y Remove the SD card from your PC, and insert the
card into the transceiver’s slot.
See page ??-?? for details of inserting the SD card
into the transceiver.
Saving the current data is recommended before
loading other data into the transceiver.
Updating the repeater list5.
u Push
SET
(C) to enter the Set mode.
i Touch the “Load Setting” item of the “SD Card” Set
mode.
(SD Card > Load Setting)
• If the specifi ed item is not displayed, touch [∫] or [√](D)
one or more times to select the page.
o Touch the ICF fi le to be loaded.
(Example: Selecting “7100_USA_130301.icf”)
• The LOAD FILE screen appears.
!0 Touch “Repeater List Only.”
• The “Keep 'SKIP' settings in Repeater List?” appears.
• Loads only the repeater list into the transceiver.
Continued on the next page ☞
Updating the repeater list (Continued)
Select the fi le
to be loaded
●
w
q
q
SD card
Transceiver
from the Card
reader
PC
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch panel)
L
eft
R
ight
C
enter
D
isplay