D Status call
A status message can be sent to the individual or despatcher
station.
The status message cannot be sent to a group stations.
• Individual status call
q Push [Up]/[Down] to select the desired individual code.
PERSON 1
w Push [Status] to enter the status message selection
mode.
e Push [Up]/[Down] to select the desired status message
from total of 32 messages (code 0 to 31.)
• The status code 0 and 31 are common message in the system.
Code 0 : Call Back Request
Code 31 : Call Cancel
STATUS 1
r Push [PTT] or [Call Set Up] to transmit the selected status
message to the selected station.
• “CALLING” is displayed.
CALLING
t When the status call is succeeded, “OK” is displayed.
OK
• Despatcher status call
q Push [Despatcher] to select the despatcher call condition.
• “DESPATCH” is displayed.
DESPATCH
w Push [Despatcher] again to enter a status message selec-
tion mode.
STATUS 1
e Push [Up]/[Down] to select the desired status message.
• Available number of messages and code numbers are the same
as the Individual status call as at left.
r Push [PTT] or [Call Set Up] to transmit the selected status
message to the despatcher.
• “CALLING” is displayed.
CALLING
t When the status call is succeeded, “OK” is displayed.
OK
11
3
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
To Next Page
Loading...
Need help?
General
