20
3
BASIC OPERATION
D Receiving a data call
q When a data call is received, beeps sound.
• “ALERTING” and the calling station code (or text name if the call-
ing code is memorized in the memory) are displayed alternately.
⇔
• When the call from a telephone, “TEL” (PSTN) or “PABX” is dis-
played.
w Push [PTT] or [#] to set the transceiver to the data receiv-
ing condition.
• “ ” blinks.
• The communication timer is displayed and starts count down.
(When no transmission time limit is set, the timer counts up.)
• The channel number and the communication timer are displayed
simultaneously (illustrated as at below right) when the communi-
cation channel number indication is set to ON. (p. 27)
• Voice communication cannot be performed even [PTT] is pushed.
e The warning beeps sound 10 sec. before the communica-
tion timer is activated.
• The communication is disconnected automatically when the
communication timer is activated.
r Push [Clear] to disconnect the communication manually.
• Pushing [M] and [#] in sequence also disconnect the communi-
cation. (10-key version only)
• The transceiver returns to stand-by condition.
• When not answering the call
If no answering call is performed by pushing [PTT] or [#], the
calling station code is stored into the call back memory. (Max.
15 calls)
• “
” blinks when a call from the station that the station code
does not stored in the call back memory, is received.
• “
” appears when the call back memory that call back op-
eration has not been performed is/are stored.
q Push [Call Back] then [Up]/[Down] to select the desired
call back memory.
• “ ” appears when the call back memory that is stored in data
communication is selected.
w Push [PTT] or [Call Set Up] to reply the call with the voice
communication.
• The calling station code (or text name if the calling code is mem-
orized in the memory) is displayed.
302
ALERTING 302
TEL PABX
TIM 0 56 0020 0 56
To Next Page
Loading...
