16
3
BASIC OPERATION
D Include call
The include call allows to make an extra call for joining an-
other station for the communication after move to a commu
-
nication channel.
The include call is made when an individual or group code
selection using a memory or keypad is performed on the
communication channel.
D 5-digit routing code call
The 5-digit routing code call provides a shortening a calling
code input.
When calling a station that has a different prefix and/or fleet
code, the 3-digit prefix and 4-digit fleet code are converted
into 2 or 3-digit code, therefore, entering a total of 5-digit
code including an individual or group code.
• The conversion range
Code within 200 to 299, 900 to 998, 20 to 29 and 90 to 99
can be converted, and set the desired prefix and fleet code
must be registered in advance.
e.g.: When the station ‘200 2001 200’ calls the station ‘211
2006 300’;
➥Register the both prefix ‘211’ and fleet ‘2006’ to “22”
as the 5-digit routing code— Enter “22300” and push
-
ing [#] to make a 5-digit routing code call.
D Call cancel
Push [
M] and [#] to cancel the call.
The communication is disconnected, and the call is can
-
celled.
D Cancelling the entered code
During code entering from the keypad, pushing [Up]/[Down]
or [Backspace] to clear the previously entered digit code.
The entered all digit code can be cancelled by pushing
[Clear].
D Manual call reply
When the call with “ALERTING” indication is received, push
[#] or [PTT] to reply the call manually (off-hook).
D End of the communication
Push [
M] and [#], or push [Clear] to finish (disconnect) the
communication (on-hook).
To Next Page
Loading...
Need help?
General
