• Erasing the call back memory
q Push [Call Back] then select the desired call back memory
to be erased with [Up]/[Down].
w Push and hold [Call Back] for 2.5 sec. to erase the se-
lected call back memory.
• All the stored call back memory can be erased with the
same operation as above depending on the setting.
• When all of the 15 call back memories are stored and
16th call is received, the called station sent the message,
“Don’t Disturb” to the system repeater. In this case, the
message that the call has failed is displayed on the call
-
ing station display.
■ Calling station ID indication
for group call
The communicating station code can be displayed at any
time.
This function can be turned ON or OFF in advance.
The “Pressel signal” from the calling transceiver is used for
the indication, however, the “Pressel signal” is not through out
with some trunking system repeater. No station code indica
-
tion is provided in this case.
NOTE: This function may function differently or not func-
tion depending on the trunking system controller in place.
23
5
OTHER FUNCTIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
To Next Page
Loading...
Need help?
General
