22
5
OTHER FUNCTIONS
■ PTT quick call
The PTT quick call provides simple calling.
Pushing [PTT] only makes a call with the displayed ID, even
individual, group, despatcher, status or call back.
NOTE: The PTT quick call will not function when [Call Set
Up] is assigned to some function key. Do not assign [Call
Set Up] when PTT quick function is used.
■ Call back function
Use this function when the called station cannot be reply the
call immediately.
Push and hold [Call Back] to toggle the call back function ON
and OFF.
When the call back function is turned ON:
The called station sending backs the “Call Back” message to
the calling station.
• “
” appears and the calling station code is stored into the
call back memory.
• “CALLBACK” is displayed on the calling station display.
• While in call back mode, two dot indications blink at the left
edge and 2nd of the LCD.
When the call back function is turned OFF:
The calling station code is stored into the call back memory
only when no reply call is performed, or the clear down oper
-
ation is performed at the calling station before reply the call.
• Up to 15 calls can be stored into the call back memory.
• “
” blinks to let operator knows the un-replied calls are
available.
• When [Call Back] is pushed to confirm the stored contents,
the call back indicator blinking stops and displayed continu
-
ously.
• The call back memory is cleared after turning the trans
-
ceiver OFF.
• The regular calling operation can be performed even the
call back function is turned ON.
q During “
” appears or blinks, push [Call Back] to display
the stored station code or text name.
w Push [Up]/[Down] to select the desired memory.
e Push [PTT], [Call Set Up] or [#] to reply to the call that
from the selected station code.
• The station code will be erased from the call back mem
-
ory when the reply call is performed.
• The call back operation cannot be performed to PSTN,
PABX, Inter-prefix and Inter-fleet calls.
To Next Page
Loading...
Need help?
General
