28
7
TALK AROUND
The transceiver has a conventional operation capability also
for when the transceiver is in out-of service area.
The tone squelch operation with CTCSS is available for the
conventional operation, as well as the ANI (Automatic Num
-
bering Identification) transmission at PTT ON and/or OFF.
NOTE: The pressel signal of trunking is used for the ANI
operation.
➥ By pushing [Monitor], both the tone and noise squelch is
released to monitor the selected channel conditions.
➥ Total of 32 conventional channels are available and are se-
lectable with [Up]/[Down].
The conventional channels must be programmed in ad
-
vance.
• Switching with the automatic talk around
The conventional mode will be selected automatically when
the trunking control channel is fall down or the transceiver
move into the out-of service area.
Even the conventional mode is selected, the transceiver
automatically searching for a usable control channel by re
-
turning into trunking mode in interval. Then the transceiver is
switched to trunking mode when a usable control channel is
found, or return to conventional mode when no usable control
channel is found.
The automatic talk around is disabled by setting “OFF” in au
-
tomatic talk around timer with the programming.
•
Switching with [Mode], or [P1] and [Up] operation at
power ON.
Push [Mode] to toggle the operation mode between trunking
and conventional mode.
Or, while pushing and holding both [P1] and [Up], turn the
transceiver power ON to toggle the operation mode between
trunking and conventional mode.
Once the operation mode is selected with either opera
-
tion, the operation mode won’t be changed until [Mode] is
pushed.
Even the transceiver is turned OFF, the transceiver remains
the operation mode.
NOTE: [Mode] must be assigned in key assignment for
both trunking and conventional if manual operation mode
selection is required.
To Next Page
Loading...
