■ Programmable function keys
The following functions can be assigned to [Red], [Clear],
[P0], [P1], [P2] and [P3] programmable function keys.
2 keys located below [PTT] are fixed for [Up] and [Down].
A different functions can be assigned for the customize keys
between trunking and conventional mode.
D Trunking mode only
DESPATCHER KEY
Push to make the despatcher call.
• The pre-programmed despatcher ID is simply recalled.
CALL1 AND CALL2 KEYS
Push to make a call to the pre-programmed station/group.
• [Call 1] calls the station programmed in channel 1 in call memory.
• [Call 2] calls the station programmed in channel 2 in call memory.
EMERGENCY KEY
Push to make an emergency call.
The emergency call calls the pre-programmed station.
• This function is assigned to [Red] in default setting.
BACKSPACE KEY
Push to erase the previously entered digit input.
STATUS KEY
Push to enter a status message selection mode.
CALL BACK KEY
Push to toggle the call back mode ON and OFF.
CALL SET UP KEY
Push to make a call.
Assign this function when the PTT quick call is not used.
D Either trunking or conventional mode
MODE KEY
Push to switch the operation mode between trunking and
conventional.
NULL KEY
No function.
Assign to the key that is not used to the transceiver opera
-
tion.
HIGH/LOW KEY
Push to toggle the transmit output power.
• When automatic power selection is enabled for trunking mode op-
eration, the transmit output power cannot be selected with this key.
29
8
PROGRAMMABLE FUNCTIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
To Next Page
Loading...
Need help?
General
