Icom IC-F7000 Instruction Manual

41
6
SET MODE
DD
Setting CH LIST (pgs. 31, 32)
q Push [OK
≈≈
] to edit ‘CH LIST.’
w Push [
∫∫
]/[
√√
] to select the desired channel or
‘<add>’ for new entry, then push [OK
≈≈
].
• Push [
ΩΩ
CLR] to return the set mode menu .
•“*” marked channel is restricted for programming or
changing. Ask your dealer.
e Push [
∫∫
]/[
√√
] to select the item or push [
ΩΩ
CLR]/[OK
≈≈
] to set the values or conditions for
each memory channel contents “Comment,” “RX
frequency,” “TX frequency,” “Call Type,” “Scan
group,” “Filter.”
r After all setting is finished, turn power OFF and ON
again to exit the Initial set mode.
Push √ or ∫
ç---CH-12
-----RADTEL
è-MODE-USB
---TX-03.760.0
---RX-03.760.0
é-TYPE-ç-TELCALL-å
--FIL--WIDE
--SCAN-2
--DELETE-NO
--<add>---------
----12-RADTEL---------å
è---15-RADTEL
-*--13-RADTEL
----14-RADTEL
SET-MODE
--CH-LIST--å
è-SCAN
--ID-LIST-
--I/O
[Ω CLR]/[OK ≈]
[∫]/[√]
DD
Setting ID LIST (pgs. 33–35)
q Push [
√√
] to select ‘ID LIST,’ then push [OK
≈≈
] to
edit ‘ID LIST.’
w Push [
∫∫
]/[
√√
] to select the desired call type, then
push [OK
≈≈
].
• Push [
ΩΩ
CLR] to return the set mode menu .
e Push [
∫∫
]/[
√√
] to select the desired ID channel, then
push [OK
≈≈
].
• Push [
ΩΩ
CLR] to return the call selection menu .
• No displayed channel is a blank channel .
• ID programming screen appears.
r Push [
∫∫
]/[
√√
] to select the item or push
[
ΩΩ
CLR]/[OK
≈≈
] to set the ID list contents.
t After all setting is finished, turn power OFF and ON
again to exit the Initial set mode.
ç---ID-1022
------NO.x0022
----åKEY-PUSH-&-HOLD
----CH-12-320
--DELETE-NO
é--1-2999-Easten----å
---2-3999-NorthEast-
---3-6999-Western---å
---4-6999-Western
è--5-7999-NorthWest
--SELCALL-----å
--TEL-NO.
è---CH-15-RADTEL
--ALE
----CH-14-RADTEL
SET-MODE
--CH-LIST-
è-SCAN
--ID-LIST--å
--I/O
[Ω CLR]/[OK ≈]
[∫]/[√]

Icom IC-F7000 Specifications

General

Brand	Icom
Model	IC-F7000
Category	Transceiver
Language	English