iCR 3600
TM
– Service Manual
3600 covers protect the service person from direct exposure to laser light. These covers will
protect a user/service person only if they are properly installed. Covers must be removed
and replaced by properly trained service personnel. Contact
i
CRco if there are any issues
with the covers being damaged or replacement covers are needed.
Electrical Hazards
WARNING
This equipment is operated with hazardous voltages which can shock, burn,
or cause death.
Notice
The
i
CR 3600 must be connected to a uninterruptible power supply (UPS). Failure
to use a (UPS) will void the warranty.
The equipment must be serviced by properly trained technicians certified by
i
CRco, Inc.
Do not connect the
i
CR 3600 with a damaged or sub-standard power cable. Do not use
an extension cord with this device. The
i
CR 3600 should be properly grounded and
power connections inspected to ensure safe operation. Use at least a 1300VA (780W)
uninterruptible power supply (UPS) with this device, as it is sensitive to variations in
power.
Malfunctioning Equipment
If any
i
CRco product shows signs of malfunction, discontinue the use of the product
immediately and contact Technical Support at 310-921-9559.
FCC Notification
This equipment generates, uses, and can radiate radio frequency energy, and if not installed
properly, can cause interference with radio communications.
Mammography Use
The iCR 3600 is not intended for Mammography use.
c
2007-2009
Confidential and Proprietary
Property of iCRco, Inc.
iv of 61 Document # 3600-02A Rev C
March 22, 2010
To Next Page
Loading...