iCR 3600
TM
– Service Manual
Safety Information
Read and understand the installation and operating instructions before applying power to
the iCR 3600.
C A U T I O N
C A U T I O N
D A N G E R
CAUTION: FOR CONTINUED
PROTECTION AGAINST RISK OF FIRE,
REPLACE ONLY WITH SAME TYPE AND
RATING OF FUSE.
CAUTION: TO REDUCE THE RISK OF
ELECTRONIC SHOCK, DO NOT REMOVE
COVER. NO USER SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
Invisible laser
radiation when open.
AVOID EXPOSURE
TO BEAM.
Class 3b laser product.
(IEC 825-1)
3A SLOW BLOW, 250VFUSE
INPUT: 100-240VAC 3A 50-60Hz
Conventions
DANGER
A DANGER indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury. This signal word is to be limited to the most
extreme situations.
WARNING
A WARNING indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION
A CAUTION indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury. It may also be used to alert against
unsafe practices.
Note
A NOTE indicates important information that helps you make better use of your
iCR 3600 and Software.
Notice
A NOTICE indicates either potential damage to hardware or loss of data and tells
you how to avoid the problem.
Laser Safety
CAUTION
This equipment employs a laser. Laser radiation may be present if the
i
CR
3600 is operated without the covers. Avoid the laser beam. Direct exposure to laser light
must be avoided.
The
i
CR 3600 incorporates a Red
≥
80mw high-power solid-state laser diode. The
i
CR
c
2007-2009
Confidential and Proprietary
Property of iCRco, Inc.
iii of 61 Document # 3600-02A Rev C
March 22, 2010
To Next Page
Loading...
