16 PRT-KLCD Protege Alphanumeric LCD Keypad User Manual | April 2011
Viewing Alarm Memory
Enter your [USER CODE] to logon to the keypad.
Warehouse
*Alarms In Mem*
Select the memory view menu item located in the view main menu [MENU,5,1]. Use the up [] and down []
keys to scroll the areas that can be viewed. If an area has alarms in memory the keypad will generate a rejection
tone beep and the display will show the memory message.
Had alarm on
Roller Door
To view the first item stored in the area memory press the [ENTER] key. The first alarm stored will be displayed
and the screen will scroll the information.
in AREA
Warehouse
The display will then show the area that the alarm occurred. If a tamper alarm occurs the first line will state that it
was a 24HR alarm.
Press [ENTER] to
acknowledge
If the user is programmed with the memory acknowledge option the [ENTER] key can be pressed to
acknowledge the alarm and remove it from the list.
Press [È] to show
next item
To view the next item stored in the area memory press the down [] key.
Press [MENU] to
exit view mode
If viewing memory is completed the user can press the [MENU] key to exit view mode and return to the main
menu where another action can be performed.
Clearing Alarm Memory
It is recommended to always take a note of the alarm memory before acknowledging the alarm or clearing the
alarm memory. The alarm memory is cleared automatically next time you ARM your Protege system if the clear
memory option is enabled for the area. Alternatively the alarm memory can be acknowledged by a user that has
the acknowledge option programmed.
To Next Page
Loading...
