PRT-KLCD Protege Alphanumeric LCD Keypad User Manual | April 2011 15
2.10 Logon To LCD Keypad
Before most operations a user MUST logon to the Protege System LCD Keypad.
Logon Procedure
To logon to the Protege LCD Keypad follow the procedures below.
Enter user
code: ******
Enter your [USER CODE] then press the [ENTER] to logon to the Protege System LCD Keypad. Each key press
will display a '*'. To restart the entry process press the [CLEAR] key.
Good Evening
J Smith
If the correct code is entered you will be presented with a welcome screen greeting you with the time of day.
If the user is programmed to view alarm memory the alarm memory message will be shown to the user before
they are automatically taken to the area control menu.
Warehouse
is DISARMED
If enabled the display will then proceed to the area control menu [MENU,1] or to the main menu depending on
the user configuration.
Log Off Procedure
The keypad will automatically log the user off after no key press for the programmed time or if the [CLEAR] key is
pressed at any time while the user is logged on.
The welcome screen display, alarm memory display and other display options can be configured per
user or per access level.
2.11 Alarm Memory
All zones that generate an alarm can optionally be stored in the event log and/or the alarm memory for the area
that the alarm was activated.
Alarms in memory
logon to view.
If an alarm has occurred on your system and the alarm memory display option is enabled the display will show
the alarm memory screen.
To Next Page
Loading...
