46 PRT-KLCD Protege Alphanumeric LCD Keypad User Manual | April 2011
8 Area Groups
Area groups are used to define what areas/partitions a user will be able to view, arm and disarm. An area group
is assigned to an access level (see page 38) to restrict the ability for a user to control an area or
partition. The
Protege system supports up to 250 area groups.
8.1 All Areas Group
The all areas group is a special area group that allows access to all areas within the system. The all areas group
is assigned to the master access level by default.
Changing the all areas group is not recommended as it will restrict access to the areas used by the
Master Access Level.
8.2 Programming Area Groups
Area groups should be programmed so that they are used for a group of users, for example administration,
warehouse and management where the groups can clearly be identified by the areas that they need to view, arm
and disarm.
Programming Area Groups
Enter your [USER CODE] to logon to the keypad.
In the example area group configuration area group AG010 is being edited. Modifying the
All Areas
group is not recommended.
Area group to
modify: AG001
Select the area group add/modify sub menu item located in the main menu [MENU,2,3]. This will take you to the
screen asking to select an area group number to modify. The first area group number will be shown. The cursor
will be located over the first number.
AG010 Name
Admin Areas
To modify the name use the numerical keys. Press the [ENTER] key to save the name and move to the next
programming screen. Press the [DISARM] key to clear the name or to recall the current name press the [ARM]
key.
AG010 ScheduleÎ
None
To Next Page
Loading...