22 PRT-KLCD Protege Alphanumeric LCD Keypad User Manual | April 2011
3 Arming/Disarming
To take full advantage of your Protege System, you should familiarize yourself with the different arming methods.
3.1 Exit Delay
After entering a valid arming sequence the exit delay time will provide you with enough time to exit the protected
area before the area arms. The keypad will generate a beep-beep tone repeatedly during the exit delay period.
The configuration of the exit delay beeper is dependent on the installation. Please verify the operation
with your security professional or property manager.
3.2 Disarming Areas
An entry point, like a front door, will be programmed with an entry delay time for an area. When an entry point is
opened, the keypad will emit a continuous audible tone until you disarm the area. Your Protege System will not
generate an alarm until this timer elapses allowing you time to disarm the area. Any zone activation on a zone that
is not designated as an entry zone will result in the alarm activating.
Disarming Your Area
Logon to the LCD Keypad by entering your [USER CODE] followed by the enter key.
Warehouse
is ARMED
The display will show the area associated with the LCD Keypad you have logged on to and the current status. If
you have access to more than one area you are able to scroll the areas using the [] and [] keys.
To search for an area by name press the [MEMORY] key to open the search screen.
Warehouse
in ENTRY delay
If you have triggered an entry zone the display will show the 'in ENTRY delay' message for the area you have
selected.
Warehouse
is DISARMING
Press the [DISARM] key to start the disarming process. The display will show the progress.
Warehouse
is DISARMED
Once the disarming process has completed the display will show the area as being disarmed. You may now
proceed to enter the area and alarms will not be activated.
To Next Page
Loading...
