26 PRT-KLCD Protege Alphanumeric LCD Keypad User Manual | April 2011
Press the [STAY] stay key. The area will enable the normal zones in the area and bypass the stay zones. The
display will show the progress.
Office
Checking zone(s)
Once the enabling of the zones has been completed the area will now ensure that the zones in the area are ready
to be stay armed.
Office
Arm complete
If all the zones are ready the area will complete the arming process and briefly display the message arm complete
to you.
Office
in EXIT delay
After the display period for the arm complete message the display will return to the area status display and show
the exit delay. You should now leave the area.
Office
is STAY ARMED
On completion of the exit delay the display will return to the area status display and show the area status as
being stay armed.
Switching From Stay To Regular/Force Armed
To change an area from stay armed to a regular or force armed mode follow the procedures for disarming an
area and then arm the area using the method required.
3.5 Force Arming
Force Arming allows you to rapidly arm the system without waiting for all zones in the system to close. During
force arming, a forced zone is considered deactivated until it closes, then the system will arm that zone. Force
arming is commonly used when a motion detector is protecting the area occupied by a keypad. For example,
when arming and the motion detector is programmed as a force zone, the system will allow you to arm even if
the zone is open.
Force Arming Your System
Logon to the LCD Keypad by entering your [USER CODE] followed by the enter key.
Office
is DISARMED
To Next Page
Loading...
