28 PRT-KLCD Protege Alphanumeric LCD Keypad User Manual | April 2011
The display will show the area associated with the LCD Keypad you have logged on to and the current status. If
you have access to more than one area you are able to scroll the areas using the [] and [] keys.
To search for an area by name press the [MEMORY] key to open the search screen.
Office
24HR Enabled
Once the area is shown, Press the [] key. The display will now show the status of the 24HR section of the area.
Office
24HR Disabled
Press the [DISARM] key to disable the 24HR section or the [ARM] key to enable the 24HR section.
Office
24HR Busy
While completing the requested operation on the 24HR area the display will briefly show the busy message to
indicate that it is completing the required action.
The 24HR section of an area is enabled automatically when the area is armed.
3.7 Bypassing Zones
Bypassing zones allows you to program the alarm system to ignore (Bypass/Deactivate) specified zones the next
time the system is armed or until the bypass is removed (Bypass/Deactivate Latched). For example, you may
wish to bypass certain zones when workers are renovating part of your establishment.
A zone will automatically have the bypass settings removed when all areas to which the zone has been
assigned are disarmed. If the bypass is a latched bypass it will remain until removed manually.
Bypassing Zones
Logon to the LCD Keypad by entering your [USER CODE] followed by the enter key.
Roller Door
is not BYPASSED
Select the bypass zones sub menu item located in the main menu [MENU,7,1]. This will display the first zone
available to be bypassed. The name will be shown on the first line of the display and then the current bypass
status will be shown on the second line. Pressing the right [] key will prompt you for the zone using the zone
reference (CP001:01).
To search for a zone by name press the [MEMORY] key to open the search screen.
Warehouse PIR
is not BYPASSED
To Next Page
Loading...
