20 PRT-KLCD Protege Alphanumeric LCD Keypad User Manual | April 2011
2.15 Access Trouble List
Access control trouble conditions monitor user operation and access control devices within the system alerting
the system manager when a user is attempting to compromise the system or a device is in an unauthorised
state.
Forced Door
A door in the system has been forced open. A forced door occurs if entry or exit from the door results in the door
being forced open. A forced door trouble condition may also occur when a door unlock emergency break glass
has been activated.
Door Left Open
A door in the system has been left in the open state or has been held open beyond the programmed door open
time.
Number Of Access Attempts
An unauthorised user has exceeded the number of times they can attempt to gain entry in to a door or the user
has entered an excessive number of incorrect PIN numbers on a LCD Keypad.
User Denied Entry
An unauthorised user has attempted to gain entry through a door.
Unknown Card
A card that is not programmed in to the system has been presented to a card reader.
Card Reader Tamper
A card reader has been removed or damaged and has failed to report to the system.
2.16 Bypassed Zone List
The bypass list is accessed from the view sub menu [MENU,5,3] and will list all bypassed zones (see page 28) in
the system.
Zone(s) bypassed
logon to view.
The display will be shown when zones are bypassed in the system and the LCD Keypad is configured to display
bypass messages.
To Next Page
Loading...
