Test Results 5-4
Figure 5-3 Cable Performance Results
The results screens for the Cable Performance, VoIP, Web and IP
Video tests all display the following information:
? Results – Indicates Pass or Fail. Fails when the number of
errored packets is greater than the number specified in the
Setup options for that test type.
? Cable ID – Displays the ID of the saved autotest.
? Cable Type – Displays the selection specified in the
Autotest/Manual tabs when the test was run.
? Packet Size - Displays the packet size transmitted during the
test. Either 64 bytes or 1518 bytes depending on the test run.
? Packet Fill – Displays the type of data used to fill the test
packets. Fixed mode uses an alternating series of “1’s” and
“0’s.” Random mode uses a random series of “1’s” and “0’s.”
? Transmitted – Displays the number of packets transmitted
during the autotest.
? Received – Displays the number of successful packets that
were received during the autotest. The bar graph indicator
provided a quick glance of the test results.
? Errored –Displays the number of packets that were lost or re-
transmitted due to packet errors. A good link will have zero (0)
To Next Page
Loading...
Need help?
General
