IFM CR711S - Output Type out PWM-N-BRIDGE-A

46
ifm Programming Manual ecomatController/60-1 (CR711S) Operating System V2.5.0.n 2017-12-19
System description Hardware description
>
Output type OUT PWM-n-BRIDGE-A
23094
n = current rating
Example: n = 25  I
max
= 2.5 A
Binary output or
analogue output with pulse width modulation (PWM), optionally current-controlled (PWM
I
)
or bridge output (via PWM)
Block diagram
OUT PWM-n-A
OUT#### = connection of PWM output no. ####
(CR) = device
(1) = measured value (analogue)
(2) = measured value (binary)
Configure input → Chapter System configuration
Possible operating modes:
 Binary output CSO (B
H
)
 Binary output CSI (B
L
)
 analogue output CSO with pulse width modulation (PWM
H
), current controlled (PWM
I
)
 analogue output CSI with pulse width modulation (PWM
L
)
 analogue output CSO with pulse width modulation, current-controlled (PWM
I
)
 Pair of outputs as bridge with pulse width modulation (PWM)
Setting and measurement via:
 FB Output (→ p. 128) for binary output
 FB PWM1000 (→ p. 156) for PWM
 FB CurrentControl (→ p. 153) for current control (PWM
I
)
 FB HBridge (→ p. 148) for bridge output