IFM CR711S - System configuration; Configure PLC; Allocate memory partition

64
ifm Programming Manual ecomatController/60-1 (CR711S) Operating System V2.5.0.n 2017-12-19
System configuration Configure PLC
7 System configuration
Configure PLC ..................................................................................................................................... 64
Configure inputs and outputs .............................................................................................................. 67
Configure interfaces ............................................................................................................................ 68
23096
>
7.1 Configure PLC
23097
23368
WARNING
The safety functionality is in preparation.
At present the device has NO safety functionality!
► Do NOT use the device for safety-related functions!
>
7.1.1 Allocate memory partition
23483
23368
WARNING
The safety functionality is in preparation.
At present the device has NO safety functionality!
► Do NOT use the device for safety-related functions!
Further information: → Memory allocation variants (→ p. 32)
To allocate the memory partitions to the PLCs:
1 Select memory partition
► In the device tree: Double-click on symbol [Device (CR711S)]
► In the editor window: Select [Memory Layout] tab.
> The editor window shows the partitioning of the memory:
Memory layout
Partitioning Safety PLC / PLC
MemoryLayout_4s_1
4 MB / 1 MB
MemoryLayout_3s_2
3 MB / 2 MB
MemoryLayout_2s_3
2 MB / 3 MB
MemoryLayout_1s_4
1 MB / 4 MB
2 Set memory partitioning
► Highlight the required memory partition
► Click on the [Update Devices] button
> Memory partitioning is adopted in CODESYS
3 Load memory partition into the device
► Click on the [Download Configuration] button
> Memory partition is downloaded to the device