3
Power
Before plugging in the cabinet, first make sure the voltage is as require
（
110V or 220V
）
, or fires and electric shocks might occur.
When plugging in the cabinet, use an outlet with ground wire.
Do not expose electrical cords and ground wires on the hallway, or damage,
electric shocks and short circuit might occur.
Do not place flammable items near electrical cords to avoid fires.
If electrical cords are to be damaged, replace new ones with your local
distributor.
To avoid electric shocks or short circuits:
Before repair or maintenance, power must be turned off.
Do not touch plugs with wet hands.
Do not immediately unplug or plug in the cabinet.
When unplugging the electric cord, tightly hold the plug and avoid
pulling the electric cord.
Transporting
When transporting this product with a forklift, make sure to exert the force
point to avoid accidents or damage to the cabinet.
When moving this product with a vehicle, make sure to fasten the caster
rather than the tail to prevent shaking, or damage might occur the cabinet.
The LCD monitor of the cabinet is rather fragile, and should be prevented
from severe shaking or being hit by outside forces.
Caution
Caution
To Next Page
Loading...
