33
3.3.3 I/O test
In the page of 【I/O test】, you can run the testing of specific application to see
if it is normally functioning or not.
Well-sensed devices will be show with a corresponding picture, value or "on"
icon.
Enter 【Operator Settings】→【1.Hardware test】→【1-3.I/O test】, and
the screen will display as below:
After you enter the page of 【I/O test】, you can run the testing of a
specific application as explained in the chart below：
Application Testing method Result
Coin Insert coins
When you insert a coin, the amount of
coins inserted will increase by 1.
Value range between 00 and 99.
Service Press the button "Off" became "On"
Test Press the button
"Off" became "On"
Start Press the button
"Off" became "On"
Calibrate
View
Press the button
"Off" became "On"
Ready Press the button
"Off" became "On"
Emergency Press the button
"Off" became "On"
Seatbelt Fasten seat belt "Off" became "On"
Steering
wheel
Turn the steering
wheel to the right
and left
When the steering wheel is turning to
the left or the right.
The corresponding status and value
will be around -1 or 1.
To Next Page
Loading...
