The StellarMate Plus Manual
15 / 341
You can select the drivers for your devices manually, or you can let StellarMate
detect them automatically by tapping on the Auto Detect button on the top-right
corner. You can then insert each device and wait for a confirmation after it gets
detected. Sometimes you need to confirm the type of device before you can
continue. This is especially important when using serial To USB adapters that are
used for mounts and focusers.
After all drivers are selected, enter the desired profile name and tap Save.
4.4 Adding Telescopes
You can specify a Primary Scope and a Guide Scope for your equipment profile.
Tap on the Add button next to the primary scope to enter the details of the
telescope. All units are in millimeters.You can specify a Primary Scope and a
Guide Scope for your equipment profile. Tap on the Add button next to the
primary scope to enter the details of the telescope. All units are in millimeters.
Optionally, you can also add a Guide scope if desired.
Optionally, you can also add a Guide scope if desired.
To Next Page
Loading...