The StellarMate Plus Manual
288 / 341
Timeline shows the major Ekos processes, and when they were active. For
instance, the Capture line shows when images were taken (green sections) and
when imaging was aborted (red sections). Clicking on a green section gives
information about that image, and double clicking on one brings up the image
taken then in a fitsviewer, if it is available.
If you have moved your captured images, you can set alternate directory in the
input menu to a directory which is the base of part of the original file path.
Clicking on a Focus segment shows focus session information and displays up
the position vs HFR measurements from that session. Clicking on a Guider
segment shows a drift plot from that session, (if it's guiding) and the session's
RMS statistics. Other timelines show status information when clicked.
Statistics
A variety of statistics can be displayed on the Stats graph. There are too many
for all to be shown in a readable way, so select among them with the
checkboxes. A reasonable way to start might be to use rms, snr (using the
internal guider with SEP Multistar), and hfr (if you have auto-compute HFR in the
FITS options). Experiment with others. The axis shown (0-5) is appropriate only
for ra/dec error, drift, rms, pulses, and hfr. These may be y-axis scaled
(awkwardly) using the mouse wheel, but the other graphs cannot be scaled. To
reset y-axis zooming, right-click on the Stats plot. Clicking on the graph fills in
the values of the displayed statistics. This graph is zoomed and panned
horizontally in coordination with the timeline.
18.4.9 Jupiter Moons Tool
To Next Page
Loading...
