iLumin SC-RP - Appendix 1: Wallstation Announce Mode; Placing Wallstations into Announce Mode; Ineo Wallstation Announce Mode; Revio Wallstation Announce Mode

P40
Appendix 1
Placing Wallstations into Announce Mode
To assist with identication within complex lighting systems, some iLumin wallstations have an ‘Announce Mode’ where
they transmit their identity across the CAN network for a short period. The way in which ‘Announce Mode’ is invoked
varies between products.
Ineo wallstation
Press and hold any button other than the raise/lower and
ON/OFF button for ve seconds.
Revio wallstation
Press and release the cleaner switch which is located
on the underside of the wallstation. The unit will remain
in announce mode for ten seconds and then return to
normal operation.
Cleaner switch - press to temporarily
invoke the announce mode