iLumin SC-RP User Manual

P23
To use the Output Override option
1. From the Operation menu, highlight the ‘Output Over-
ride’ option and press the
ENT
button. The display will
show the available options:
2. Use the or buttons to highlight the ‘Each
Output’ option and press the
ENT
button.
3. Use the or buttons to highlight each Output
sequentially and then, either:
• Use the or buttons to decrease or increase
the dimming level, or for non-dim loads, switch the
load on & off, or
• Use the numeric keypad to enter a level from 0 to
100% and then press the
ENT
button to set the
Output to the selected level.
4. Check that the load responds as expected and then
return the level to zero or off using either of the above
two methods.
5. Repeat Steps 3 & 4 for each Output. If the loads do
not respond correctly, verify the output programming
from Step 6 on Page 20.
Override-Options
All Outputs
Each Output
Select Scene
Override: Each Output
Output1 100%
Output2 100%
Output3 100%
Output4 100%
Step 7: Verify proper control of each Output using the Output Override option
Objective: To prove that each Output can be controlled by dimming commands.
Help
OutputOverride
TimeclockManager
PowerData
OperationMenu
Override - Options
AllOutputs
Each Output
Select Scene

iLumin SC-RP Specifications

General

Brand	iLumin
Model	SC-RP
Category	Controller
Language	English