Name: Immergas AUDAX TOP ErP Series
Brand: Immergas
Rating: 5 (1 reviews)

To Next Page

To Previous Page

AUDAX TOP ErP and Integrated System

Each time AUDAX TOP ErP is operating, the Manager enables

an additional control, which checks the time it takes the system

to reach full operation: when a maximum time is exceeded (can

be set dierently between C.H. and D.H.W.) for the heat pump

to reach the owT, the boiler or integrative electrical resistance

is started.

It is also possible to choose the integration operation method

(boiler/resistance) between simultaneous or alternative Heat

Pump.

In all cases where radiant panels are also included for summer

cooling, alongside dehumidiers (see previous picture), the

System Manager will also monitor the dew point through the

installation of room probes (Immergas). anks to this intelligent

function the System Manager can increase the ow temperature

to the radiant panels by about 1°C (up to a maxT of 18°C - maxi-

mum limit of the cooling heat pump), avoiding the phenomenon

of condensation on the surface of the structure. is function can

only be activated with an Immergas accessory kit that controls

humidity. In some cases, for example, the System Manager can

turn the heat pump o if the ow temperature to the radiant

panels is not suciently corrected.

If on the other hand, there is a high temperature zone in the

system, in addition to the low temperature one, it will be served

exclusively by the boiler through an accordingly congured

dedicated expansion connected to the System Manager.

D.H.W: operation: amongst the possible congurations with

integrated systems is the option to connect the boiler and

AUDAX TOP ErP parallel with the same coil, and use a storage

tank probe with one DHW set for the entire storage tank, and set

it in the system's Manager. If the system Manager is connected

to the boiler on external probe clamps (pre-set models), if the

set DHW temperature is < 50°C, the heat pump starts (always

checking the aforesaid convenience); however, if it is > 50°C,

AUDAX TOP ErP heats up to 50°C, then the boiler starts; if

there is no boiler but there is storage tank integrative electrical

resistance, the water is brought to 50°C via the heat pump and

AUDAX TOP ErP is then disabled, leaving the resistance to

integrate to the pre-set value.

In systems where there is a boiler or an integrative electrical

resistance on the storage tank, in addition to the heat pump, it

is also possible to enable the anti-legionella function.

voltar.com.ua

Immergas AUDAX TOP ErP Series User Manual

Table of Contents

Questions and Answers:

Immergas AUDAX TOP ErP Series Specifications

Related product manuals

Brand	Immergas
Model	AUDAX TOP ErP Series
Category	Heat Pump
Language	English