Immergas AUDAX TOP ErP Series User Manual

AUDAX TOP ErP and Integrated System
83
1 2
3
5
4
7
8
9
6
10
Dehumidication mode with cooled air
In this case, the cooling circuit performs 100% of condensation in water via the heat exchanger (6). e condenser (5) is
cut-o via the valve (10) and the air sent into the room is the same – cooled and dehumidied – at evaporator outlet (3).
46.3 LAYOUT AND WIRING DIAGRAMS
A15
S50S20
Enabled in cooled
air mode
Alarm signal
Enabled in neutral
air mode
Remove to connect
the Humidistat
Remove to
connect TA
Remove to connect
the expansion
Sel. Fan
speed
Power supply
Power supply
To the System
Manager
Dehumidier Expansion board for zone management
voltar.com.ua voltar.com.ua voltar.com.ua voltar.com.ua
voltar.com.ua voltar.com.ua voltar.com.ua voltar.com.ua
voltar.com.ua voltar.com.ua voltar.com.ua voltar.com.ua
voltar.com.ua voltar.com.ua voltar.com.ua voltar.com.ua
voltar.com.ua voltar.com.ua voltar.com.ua voltar.com.ua
voltar.com.ua voltar.com.ua voltar.com.ua voltar.com.ua

Immergas AUDAX TOP ErP Series Specifications

General

Brand	Immergas
Model	AUDAX TOP ErP Series
Category	Heat Pump
Language	English