37
2.10.2 Meter counting (optional)
When using meter counting, the driven distance can be shown at the display. The meter
counting is used for rough orientation only, even if exactly adjusted. Therefore, it is not
appropriate to calculate junctions for the renovation of inliner.
The meter counting can be drawn upwards out of the transport position and then hinged in
front of the drum. This has to be done carefully so that the cable will not be jammed.
WARNING! There is a crushing hazard for the fingers!
Now the supply hose can be hinged. For this, unscrew the black pressure roll, hinge the hose
and screw the roll again.
When using the meter counting for the first time, it could be that the calibration value has to be
entered. (However, this value is preset by the manufacturer.) Disconnect the device from the
power supply (activate the emergency stop!)!
Connect the keyboard. Switch on the device again (pull the emergency stop button!).
Afterwards, press the key combination Strg + Alt + Shift + F8 and enter the value 0,575. Press
To Next Page
Loading...