38
ENTER and leave the menu by ESC. The new value will be valid only after the drum has been
separated from the power supply and then again connected! For that purpose, press the
emergency stop and switch on the device again by pulling the emergency stop button!
After completion of the work, hang out the hose from the meter counting, bring the meter
counting in transport position and secure the hose at the drum.
2.11 Cutting tools
2.11.1 Overview
We recommend the use of original IMS cutting tools for operating the cutter. These cutting
tools were developed in connection with the cutter to ensure its longevity and dependability.
The original IMS cutting tools fulfil the requirements regarding quality, stability, true running
and especially structural properties.
Tool extenders, wire brushes or other tools which are not adapted to the cutter, may cause
damage to the cutter.
To Next Page
Loading...