Inficon Ecotec E3000 530-001 - General Information; 1.1.1 Intended Use

General Information 1-1
kina22e chapter 1.fm technical handbook(1206)
1 General Information
The Ecotec E3000 refrigerant leak detector is supplied ready for operation. However,
we recommend that you carefully read the Technical Handbook to ensure optimum
operating conditions right from the start. This handbook contains important
information on functions, installation, start-up and operation of the Ecotec E3000.
1.1 Introduction
1.1.1 Intended Use
The Ecotec E3000 is a refrigerant leak detector for sniffer applications. It may be
used to localise and quantify leaks in test samples if there is a refrigerant under an
overpressure within the test sample and when searching the test sample with a
sniffer probe from the outside (sniffer method). The use of this sniffer probe is
mandatory for proper operation and it is available as an accessory (Cat. No. 525-001
to 525-004).
Proper use includes:
• Conformance with the technical specifications
• Use of standard and original accessories
• Observance of the instructions and guidelines contained in this document
Caution
The Ecotec E3000 must not be operated while standing in water or when exposed
to drip water. The same applies to all other kinds of liquids.
This Ecotec E3000 should only be used in rooms.
Caution
Avoid contact of the Ecotec E3000 with bases, acids and solvents as well as
exposure to extreme climatic conditions.
Caution
Ensure sufficient air cooling (see also Section 1.1.2)