4-14 Equipment Settings
kina22e chapter 4.fm technical handbook(1206)
Cal
In the CALibration submenu an internal calibration can be
ENABLED or DISABLED.
If the function is set to
DISABLED, only a proof function with the built-in ECO-Check
reference leak will be possible.
Default value:
ENABLED
Change menu PIN
Any changes to the current settings may be password protected. The menu PIN can
be changed in the “change menu PIN” submenu.
If a new PIN is entered the Ecotec E3000 software will ask to repeat the new PIN to
prevent entering errors. Afterwards the menu PIN will be changed to the new value.
Notice: The operator needs to go back up through the main menu for this change
to become effective immediately. Otherwise, the new PIN will be activated
after 5 minutes.
A menu PIN of “0000” means no password protection, all menus can be freely
accessed.
Default setting: 0000
4.5.2 Audio Functions
In the AUDIO sub-menu all settings regarding the different audio alarms of the Ecotec
E3000 can be edited.
Beep sound
Beep sounds are sounds that are issued as confirmation of certain functions, e.g.
completion of a calibration process.
This acknowledgement sounds can be enabled or disabled in the beep sound
submenu.
Default value: enabled.
Fig. 4-14 Setting-up a Menu-PIN for parameter protection
To Next Page
Loading...
