Equipment Settings 4-27
kina22e chapter 4.fm technical handbook(1206)
4.6.4 Baud rate & end sign
The BAUD RATE can be set to values between 1200 and 19200. Default setting: 9600.
The
END SIGN can be set to Carriage Return (CR), Line Feed (LF) or to CR+LF.
Default setting: CR+LF.
4.6.5 Select PLC Inputs
In the SELECT PLC INPUTS submenu the user can select which pin on the I/O port
(suitable for PLC input) represents which command. The default setting is as follows:
To change these settings select the appropriate pin with the UP and DOWN arrows
on the left side of the display and afterwards select the desired command from the
list of commands with the UP and DOWN buttons on the right side of the display.
Press OK to save your settings. A screen with all selected settings will be displayed
for your reference. Confirm with OK again.
Point 03 12.2 g/a
Point 04 0.1 g/a
Global 13.04.2007 11:57:03 12.5 ga
Point no. Date Time Leak rate Unit
Pin Command Pin Command
7 Sleep 13 Gas b
8 Not used 20 Zero
9 Gas a 25 Gas select
Fig. 4-21 Defining PLC-Inputs from list of possible commands
To Next Page
Loading...
