3-10 Operation of the Ecotec E3000
kina22e chapter 3.fm technical handbook(1206)
After the first location has been confirmed the message “leak check point1” will be
indicated on the main unit display and the elapsing measurement time (stored in the
testing program) will be shown in the lower part of the menu page.
Please make sure to hold the sniffer tip in the right testing location during the total
measuring time. During this time a ticking sound will be issued by the main unit and
a beep will indicate that the measuring time has elapsed and the sniffer tip can be
moved again.
After the measurement time has elapsed the message “Move to point 2” will be
displayed on the main unit. The probe display will read “tip to pos. 2”.
Please move the sniffer tip to the next testing location and if the wait time indicated
in the display has elapsed, you may start the next measurement.
If the operator tries to start the next measurement before the wait time has elapsed,
Fig. 3-10 I•Guide screens during measurement (one gas selected)
Pos. Description Pos. Description Pos. Description
1 Selected program 4 Elapsing measuring 6 ZERO button
2 Gas type stored in the time 7 I•Guide button
selected program 5 Summarized global
3 I•Guide message leak rate per unit
under test
Fig. 3-11 I•Guide screen during measurement (two gases selected)
Pos. Description Pos. Description
1 Selected program 4 Elapsing measuring time
2 Gas type stored in the selected program 5 Summarized global leak rate per
3 I•Guide message unit under test
To Next Page
Loading...
