4-2 Equipment Settings
kina22e chapter 4.fm technical handbook(1206)
2 Start / Sleep
3 Service
5 Gas Trigger 5 Gas 1 Name 8 Edit
6 Gas 2 Mode (Gas)
7 Gas 3 Trigger&Unit
8 Gas 4 Search&Limit
Internal cal.
Mass
Cal. Factor
Last cal.
Cal. Mode
2 User gas User library no. 8 Edit
Name
Mass
Factor
Molecule mass
6 Settings 2 Vakuum & access 2 Zero
3 Zero time
5 Flow limits upper limit
lower limit
6 Sensitivity check
7 Calibration
8 Change menu-PIN
3 Audio 2 Beep sound
3 Audio intern
5 Audio Sniffer
6 Alarm type
7 Volume
5 Setup I-Guide 2 I-Guide ON/OFF
Meas. 1...10 3 Edit:
Name
Gas A
Gas B
Glob. Trigger A
Glob. Trigger B
No. of points
Measuring time
Wait time
4 Button ON/OFF
6 Miscellaneous 2 Language
3 Time & date
4 Sniffer light
5 Pressure unit
6 Leak rate filter
7 Alarm delay
8 Wake up
7 Display 2 Contrast
3 Peak hold
6 Gas select
7 User mode
8 Interfaces 2 Control location
3 Recorder outputs
5 Setup PLC 5 Define PLC inputs
6 Define PLC outputs
6 RS232 protocol
7 Baud rate & End sign
8 ECO-Check
(1)
7 History & 2 Error history
Maintenance 3 Calibration history
4 Select filament
(1)
5 Maintenance interval
6 Maintenance history
7 Sniffer tip filter
(2) (1)
only in user mode "Advanced"
7 Confirm maintenance
(1)
8 Replace ECO-Check
(1) (2)
only in user mode "Standard"
8 Info 1/9 General data
2/9 Turbo molecular pump data
3/9 Transpector data
4/9 ECO Check data
5/9 Sniffer line data
6/9 I/O-Port data
7/9 Analog data
8/9 Analog data (2)
CAL-->
External Calibration
9/9 Info RS232 Adjust IGS (2)
Main menu
To Next Page
Loading...
