Inficon Ecotec E3000 Original Operating Instructions

64 8 Maintenance
Translation of the original operating instructions Ecotec E3000, kina22en1-19, 1507
Fig. 42: Calibration list
To have the complete calibration information displayed, select the appropriate line and
press the key with the magnifying glass. The calibration information includes:
 Calibration mode (internal or external); for internal: gas in calibrated leak
 Gas
– Internal calibration: one or more gas numbers
– External calibration: gas number, mass position, gas
 Date and time of calibration
 Number of operating hours at the time of calibration
 Calibration factor
 Peak position (if different from mass position)
 Flow through sniffer line at the time of calibration
 Cathode that was in use at the time of calibration (A/B)
 Size of the calibrated leak that is used (external calibrated leak for external calibration
and ECO-Check for internal calibration)
 Argon flow and mass deviation at the time of calibration
 Flow of the gas that was calibrated and background signal
Maintenance intervals To call up the elapsed operating hours of the device since the start-up, select
“Maintenance intervals”. The information does not apply to the sniffer line because
different lines could have been used.
The remaining operating hours up until the next maintenance work are displayed below.
The times below “Next maintenance for …” are based on confirmations that you enter
after maintenance work, see “Confirm maintenance”, page 65.

Inficon Ecotec E3000 Specifications

General

Brand	Inficon
Model	Ecotec E3000
Category	Security Sensors
Language	English