TLE5012B
Pre-Configured Derivates
User’s Manual 103 Rev. 1.2, 2018-02
7.4 PWM-type: E5020
The TLE5012B E5020 is preconfigured for Pulse-Width-Modulation interface with high frequency. It is most
suitable for steering angle and actuator position sensing.
• PWM frequency is 1953 Hz.
• Filter update time is 42.7 μs.
• Error indication enabled
• Autocalibration mode 2 enabled.
• Prediction disabled
• Hysteresis disabled.
• IFA (PWM) pin set to open-drain output.
• SSC interface’s DATA pin is set to push-pull output.
• IFA/IFB/IFC pins set to weak driver, DATA pin set to medium driver, fast edge.
• Voltage spike filter on input pads enabled.
7.5 SPC-type: E9000
The TLE5012B E9000 is preconfigured for Short-PWM-Code interface. It is most suitable for steering angle and
actuator position sensing.
• SPC unit time is 3 μs.
• Duration of the master pulse to trigger SPC output is 90*UT.
• 12-bit angle resolution.
• Filter update time is 85.4 μs.
• Autocalibration disabled
• Prediction disabled
• Hysteresis disabled.
• IFA (SPC) pin set to open-drain output.
• SSC interface’s DATA pin set to push-pull output.
• IFA/IFB/IFC pins set to weak driver, DATA pin set to medium driver, fast edge.
• Voltage spike filter on input pads enabled.
To Next Page
Loading...