InFocus IN5542 - Connecting with Your Devices

11
Setting up
Connecting with your devices
Before connecting the projector to your devices, check the device manual to
ensure that the device is compatible with this projector and to check what is
required for the connection.
Consult your dealer when the required accessory did not come with the product or
the accessory is damaged. It may be regulated by some standards.
►Use only the accessories specied or recommended by
manufacturer. Do not modify the projector or its accessories.
►Do not connect or disconnect the projector with devices while they are
connected to a power supply except when directed by the device manuals.
WARNING
►Some cables may need to be specic lengthes, or have a
ferrite core at the end to connect to the projector, under the regulation of electro-
magnetic interference. When a ferrite core is attached to a specic cable only at
one end, connect the end with the ferrite core to the projector.
►Be careful not to put a connector into an incorrect wrong port or in the wrong
way.
►Be careful not to damage the cables. Route the cables so they will not be
stepped on or pinched.
CAUTION
(continued on next page)
• For this product, the optional cable cover is available for purchase. To
place an order for it, please contact your dealer with the part name (77).
NOTE
After making sure that the projector and the devices are turned off, perform the
connection, according to the following instructions. Refer to the illustrations on
subsequent pages.
►Do not turn your device on prior to the projector, except when
directed by the device manuals.
NOTICE